Well you could just configure 2 static routes on the lan router, each one pointing to a different ISP, this will give you two default routes, and allow you to split the load across these.
Another way would be for you to ask the ISP's to send you partial routes and a default, that way they will send you all prefixes that they are responsbible for, ie part of their ISP setup, all of their customers etc. This way your router would use the closest match for routing to a specific ISP's local routes, and use the default for any other routes, not part of either ISP's local network.
ip route 0.0.0.0 0.0.0.0 184.108.40.206
ip route 0.0.0.0 0.0.0.0 220.127.116.11
Where 18.104.22.168 & 22.214.171.124 is the isp inside router address that connects to your router.
Meant to add, you would prob want to check out the PBR tracking options available so that if you were sending all traffic from one network down to a certain isp router, then if that isp router went away, failure etc, that this traffic gets rerouted to the other isp router.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...