Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

routing discrimination using only NAT , Is it possible ?

Hi everybody

I am dealing to configure correctly one router in order to get that users can reach public ip addresses using a private and the public address at the same time. Is it possible to solve my problem using only NAT ?

Here below you can see the ip nat that I was applying a nat static configuration and I removed it so that users could access directly to the public addresses but now they want keep accessing to the private addresses

ip nat outside source static 57.253.47.1 10.1.74.100 no-alias

Any suggestion would be greatlY appreciated

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: routing discrimination using only NAT , Is it possible ?

It is not possible to discriminate routing using NAT only. You will have to use policy based routing for this.

2 REPLIES
Bronze

Re: routing discrimination using only NAT , Is it possible ?

It is not possible to discriminate routing using NAT only. You will have to use policy based routing for this.

New Member

Re: routing discrimination using only NAT , Is it possible ?

Thanks a lot for your comments.

105
Views
0
Helpful
2
Replies
CreatePlease to create content