If you traceroute stop on the first hop that does not necessarily mean that packet also stops there. Traceroute is UDP and rely on ICMP unreachable's sent from each hop. If UDP is blocked or no ip unreachables configured on the further hop - then you will not see any traceroute reply. SO this is not reliable test.
So you have your DNS resolved - good. Now keep in mind that connection to Internet is not only traffic forwarded to Internet but also traffic being sent from Internet to your source address and you need to check that both flows are working.
First check the forward traffic - see if your router has a correct route/default route to Internet ip address. Then make sure you have correct NAT on your router.
Basically you can configure router to do Policy Based Routing - to send particular traffic to the next hop which you explicitly specify - in that way outer will not rely on it's routing table. But this will depend on the router model.
Configs and show commands may help to look at your problem deeper.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...