Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Routing issue with Cisco 1721

I have connected two Cisco 1721 via a T1 line and WIC1 cards. One router is connected to our main 192.168.8.XX subnet. Other router is connected at a remote location to the 192.168.6.XX subnet. Routers can pass network traffic and browse the network.

I need to run UPS Worldship software from the 192.168.6.XX subnet to connect to a proxy server on the 192.168.8.XX subnet. Unfortunately UPS software only works if it connects from a 192.168.8.XX.

I've attached the config files from the two 1721 routers and want to find out how I can modify the routing on the 192.168.6.XX router so I can pass the UPS traffic to the 192.168.8.XX subnet. I tried changing the fastethernet0 port on the 192.168.6.XX router to a 192.168.8.XX ip address and use the same subnet on a computer but I could not reach the 192.168.8.XX subnet with that setup.

Any ideas would be appreciated.

I attached the config files from both routers.

1 REPLY
New Member

Re: Routing issue with Cisco 1721

Can you remove access-lit 7 from 192.168.8.0 router...

Also can u post sh ip route from, both he routers and trace to the destination from both the routers.

105
Views
0
Helpful
1
Replies