Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Routing issue

In cisco switch 3640 we have two routes as below:

192.168.40.0 via tunnel0

192.168.0.0 via serial1

Now I want to ask that , if traffic comes into switch for route 192.168.40.0,would it not be routed via serial path, or traffic destination 192.168.0.0. routed via tunnel.. how do I specify exact path when such scenario comes ?

3 REPLIES
New Member

Re: Routing issue

Hi

What is the netmask declared for the subnet whose routing is pointed towards the tunnel0 interface? If it is /24 it will take the Tunnel0 interface, as longest match is preferred first.

Routing thru the serial0 has been done for /16. So it is not the prepared path.

New Member

Re: Routing issue

Ok that's fine.. My one question is Can we put traffic on priority based on protocols like I want to set priority to UDP packets in cisco switch 3600

New Member

Re: Routing issue

Hi,

U can definitely prioritise the traffic using QOS.

Define an access-list where in u will match any traffic using UDP service.

Then create a class map and match the access list in that. after that create a policy map where u will have to match the class map which u have defined in the earlier step.

After that, within in the policy map , u will have to prioritise the traffic either using DSCP or using IP precedence. The DSCP value ranges between 0-63 with 0 being the lowest and 63 being the highest. the higher the value , the more is the priority. The same is the case with IP precedence also. However, in IP precedence , the value ranges between 0 - 7.

Finally u will have to apply the poicy map in the outgoing interface as SERVICE POLICY OUTPUT.

Hope this will serve the purpose.

Pls rate the post.

100
Views
0
Helpful
3
Replies