Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

routing over access link?


is this setup valid?

right inervlan routing works fine. I have no issues with this. routing between l3 switch and router works fine as well however i dont understand how this works

router has an ip of that is connected to l3 switch which is on access vlan 99. the interfacce svi for vlan 99 is

my questions is the port thatgoes from rouer ( to core switch ( is an access port on vla 99 (with svi how will this work? there is no routing on the core switch. just static route   wont the access port only carry vlan 99 traffic ? so if any ip on vlan 10 or 20 0r 30 or 40 wants to communicate to outside world, how will it do ?

outside world









int vl 99                        trunk on both sides                                   trunk on both sides

Core switch------------------------------------------Edge switch1 -------------------------------------------Edge switch 2

(layer3 switch - Inter vlan routing)

int vlan 10                       int vl 10-                                        int vl 30 -

int vlan 20                       int vl 20 -                                       int vl 40 -

int vlan 30

int vlan  40

New Member

Re: routing over access link?

Can you check your post as it has the router and the SVI on the same IP address? I can't really read the diagram on iPhone resolution but I see it is different IPs here.

Sent from Cisco Technical Support iPhone App

CreatePlease login to create content