Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Routing Problem

Dear ALL

There is a problem that i am facing on a 3745 router. there is one wic-adsl card for connecting the internet which is working fine, recently a leased line with static ip has been brought from the isp. The problem is this that when the lease line inter face (SERIAL INT) is up the users lose the internet connectivity because all the traffic gets routed to serial int(static ip) rather then adsl(dynamic IP).

i tried chaning the routes but its not working out can some one please help me in this regard

Thanks

8 REPLIES
Silver

Re: Routing Problem

Please post your current config and your topology.

And what is the purpose of the leased line? To connect to a remote site?

New Member

Re: Routing Problem

Dear Ahmed i have attached the show run and show ip route and show ip int brie details

in show ip route there is one with serial interfface up and one is with serial int down

thanks

Silver

Re: Routing Problem

Where does the serial line go to? Do you really need to have a default route pointing to it? If it is going to another branch office you should route only relevant traffic to it.

Also you do not need to route to both ATM0/0, 83.110.225.133 and dialer1. Routing to dialer1 is enough. Maybe you can have something like:

ip route x.x.x.x m.m.m.m serial0/1 (only relevant traffic)

ip route 0.0.0.0 0.0.0.0 dialer1 (the rest goes here)

New Member

Re: Routing Problem

this serial link is between office in US and dxb and application will be used through this interface

what do u mean by m.m.m.m

Silver

Re: Routing Problem

By that I mean the network (x.x.x.x) at the far end of the serial and its mask (m.m.m.m).

New Member

Re: Routing Problem

Dear Ahmed i tried doing what u just said but still no use

the serial int ip is 83.111.225.134/30 and the isp gateway is 83.111.225.133

same thing is happening when i define the route ip route 0.0.0.0 0.0.0.0 int s0/1.

do u think that policy based routing will help ???

Silver

Re: Routing Problem

let us suppose you have this network on your remote office: 182.160.23.0/24. then you should have:

ip route 182.160.23.0 255.255.255.0 83.111.225.133

ip route 0.0.0.0 0.0.0.0 dialer1

in this case the traffic that matches the specific route (traffic to your remote site) will be sent using serial0/1. All other traffic will be sent over the default route (ADSL).

And of course, you can use PBR to accomplish the same task.

New Member

Re: Routing Problem

Thanks Ahmed for your prompt response i will try this once i get to the client site tomorrow, one more thing the isp has also provided the client with 5 more useable ip addresses 128 to 133 where x.x.x.133 is ther serial interface ip address. how will the users be able to communicate with the current setup. do i need more nat on the router.

130
Views
0
Helpful
8
Replies