Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Routing Problem

Hi there,

I have kind of a routing problem. At the moment I have a cisco 1800 Router (10.17.2.1) which is the default Gateway in a 10.17.0.0/16 Net. All traffic to other 10.x.x.x Networks is routed over the Routers MPLS WAN Port. The default Route (for all other non 10.x.x.x traffic i.e. Internet etc) points to 10.17.0.1 a Router which is our Internet GW.

How can I configure the C1800 to send all Internet bound Http/Https traffic through its MPLS WAN Port but all other non HTTP/HTTPS internet bound traffic to our local GW 10.17.0.1 ?

Hope you can help.

Best....Andy

1 REPLY
Hall of Fame Super Blue

Re: Routing Problem

Hi Andy

You need to look at Policy Based Routing which allows you to specify the next-hop based on criteria other than just the destination IP address.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a008075fae6.html

HTH

Jon

93
Views
0
Helpful
1
Replies