i have a 2811 router with a bvi interface with bridge-group f0/0 and vlan1 which vlan1 has clients connection to the network. Is it possible to have all the client(fa1/1, fa1/2,etc..)traffic pass through fa1/7???
Hi, you can add the interfaces to the bridge group this will enable the router to bridge the traffic across the interfaces in the bridge-group. You can use a route map to send traffic from client across the bridg-group also. Have a look at the document from the link below and thesample config, this should help you.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.