Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

routing table - all routers IS-IS L1/L2

There are two areas area 1 and area 2, all have L1/L2 IS-IS running.

How are the routes outside area 1 going to appear, as i L2 or i *L1 in the routing table of router A and through which interface. Please see picture attached.

1 REPLY
Hall of Fame Super Silver

Re: routing table - all routers IS-IS L1/L2

Hello Gentian,

even if routers and links are L1/L2 capable the type of adjacency between two routers in different areas can only be L2 because the net-id (the CLNS address) is different.

So RA should see Area2 IP routes as i L2 and via its link to area2 labeled E1.

Hope to help

Giuseppe

109
Views
0
Helpful
1
Replies