Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

RPF Failure on MVPN Enabled ATT AVPN Circuit

I'm trying to get multicast stood up across an ATT MPLS network that is supposed to be multicast enabled.  The PIM neighbor comes up fine, but when i try to do an mtrace back towards the RP, or anything else really, I get the following output.  I'm having a difficult time finding any explanations on the mtrace output.

 

RemoteRouter#mtrace 10.1.252.1
Type escape sequence to abort.
Mtrace from 10.1.252.1 to 10.111.30.1 via RPF
From source (?) to destination (?)
Querying full reverse path... 
 0  10.111.30.1
-1  10.111.30.1 PIM  [default]
-2  0.0.0.0 PIM No route !RPF!10.111.30.2

 

RemoteRouter#sh ip pim neigh
PIM Neighbor Table
Mode: B - Bidir Capable, DR - Designated Router, N - Default DR Priority,
      P - Proxy Capable, S - State Refresh Capable, G - GenID Capable
Neighbor          Interface                Uptime/Expires    Ver   DR
Address                                                            Prio/Mode
10.111.30.2       Serial0/1/0              05:29:45/00:01:17 v2    1 / G

73
Views
0
Helpful
0
Replies
CreatePlease to create content