04-05-2008 04:58 AM - edited 03-03-2019 09:26 PM
Hi,
My 2811 power supply stuck in "in use" status after a power supply failure.
When I put again the 2811 power supply, the supply stay provided by the RPS2300.
#sh environment
Main Power Supply is AC
Redundant Power Supply is attached
RPS status: in use
Fan 1 OK
Fan 2 OK
Fan 3 OK
System Temperature: 29 Celsius (normal)
Environmental information last updated 00:00:10 ago
#
I have performed the same with 3750E no problem and have the same problem with CCME 2851 see my other post http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cc02696
Many thanks in advance for your return.
Olivier
Solved! Go to Solution.
04-07-2008 08:09 AM
Only the Catalyst E Series switch is capable of reverting back to its own power supply without rebooting. All other devices might reboot when reverting back to their own power supplies (with a manual power cycle of the RPS).
HTH
04-07-2008 08:09 AM
Only the Catalyst E Series switch is capable of reverting back to its own power supply without rebooting. All other devices might reboot when reverting back to their own power supplies (with a manual power cycle of the RPS).
HTH
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: