Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

RTP compression enabled, but not?

All,

I've enabled rtp compression on my serial interface, but it doesn't show to be enabled:

interface Serial0/0/0:1
ip address x.x.x.x x.x.x.x
encapsulation ppp
ip tcp header-compression iphc-format
no cdp enable
service-policy output OUTBOUND
ip rtp header-compression iphc-format
end

sh ip rtp header-compression s0/0/0:1
RTP/UDP/IP header compression statistics:
Interface Serial0/0/0:1 (compression off, IPHC, NON TCP)
    Rcvd:    0 total, 0 compressed, 0 errors, 0 status msgs
             0 dropped, 0 buffer copies, 0 buffer failures
    Sent:    0 total, 0 compressed, 0 status msgs, 0 not predicted
             0 bytes saved, 0 bytes sent
    Connect: 16 rx slots, 16 tx slots,
             0 misses, 0 collisions, 0 negative cache hits, 16 free contexts

Why is it doing this?

Thanks,

John

HTH, John *** Please rate all useful posts ***
2 REPLIES

Re: RTP compression enabled, but not?

Okay,

I took off the header compression config from the serial interface, and I applied it in the policy-map under the class VOICE. I get the same thing though. Is it working the way it's expected?

Service-policy output: OUTBOUND

    Class-map: VOICE (match-all)
      57752 packets, 7203296 bytes
      5 minute offered rate 32000 bps, drop rate 0 bps
      Match: access-group name VOICE
      Queueing
        Strict Priority
        Output Queue: Conversation 264
        Bandwidth 768 (kbps) Burst 19200 (Bytes)
        (pkts matched/bytes matched) 5556/689952
        (total drops/bytes drops) 0/0
      compress:
          header ip rtp
          UDP/RTP (compression off, IPHC, NON TCP)
            Sent:    0 total, 0 compressed,
                     0 bytes saved, 0 bytes sent
                     rate 0 bps

      QoS Set
        dscp ef
          Packets marked 902       <---- It's matching the source traffic and applying the tag

Thanks,

John

HTH, John *** Please rate all useful posts ***

Re: RTP compression enabled, but not?

I scratched it....I read that on T1 lines and over it's generally not recommended to enable anyway

HTH, John *** Please rate all useful posts ***
152
Views
0
Helpful
2
Replies
CreatePlease login to create content