We would like to run Transporter in batch mode but receive the following error:Launcher Error: Job command (C:\program) not found and the job status is 'error occurred'.
Attached/included is the job definition setup to transport one job from our development environment to production. We are using 6.2. Any suggestions to correct the error. It appears that the path syntax is not correct. Thanks.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...