Yes, you should be able to ping from one to the other...The router knows both routes as "connected" routes and will route between the 2. The only thing that you need to make sure of is that you have your firewall disabled on both hosts.
You will likely need to either enter a route in each PC to the destination network (with a next hop of the routers local interface), or use the more familiar method of configuring a default gateway on each PC (the default gw will be the IP of the router interface connected to that PC). Each PC will need to know where to send traffic destined for the external network.
As j.blakley noted, the router will not need any explicit routes configured since both networks are directly connected.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...