I am trying to configure the Cisco SAMI GGSN. When i access the module (LCP) through the session slot X processor 0 command, none of the GGSN commands are available knowing that i am being redirected to the Switch: prompt.
I tried to access any of the available PPC from SUP using the session slot X processor 3...till 8 but they are not accessible.
Also when I issue the command: show sami processors. I see all processors as UNKOWN. Any idea, if this is normal? and how can i proceed?
the documentation tells that i should access one of the 6 processors through session slot X process 3 till 8.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...