I always have save the cisco switches configurations thru telnet onto either a word or text file. I notice however whenever I saved configs it saves the page breaks, etc. Two questions, First what is the best way or steps to copy the switch config files thru telnet. Second, is there a way to save the configs thru without the unnecessary page
breaks because I trying to save them onto network drive just in case that switch goes bad. Thanks.
<0-512> Number of lines on screen (0 for no pausing)
Another possibilty is to use a tftp server and the "write net" command. I mostly give these files the extension .wri to be able to open them directly with wordpad. As the configs are in unix format (LF instead of CR-LF) you will not have proper text formatting when using notepad to read them.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...