i have a RS232 device that connect to 2600 router and the router configuration is:
no ip address
sdlc role primary
sdlc vmac 4000.0018.6600
sdlc address A5
sdlc xid A5 05D018A5
sdlc partner 6600.0000.9918 A5
sdlc line-speed 19200
sdlc dlsw default
This is a cisco router with DLSW configuration and i have a problem with the work speed of the device,any operations took many time more than the same device how connect to ibm router,why that maybee configuration or ios.
I notice that the link from this router to its peer appears to be 128 K. Also that you are running DLSW on the Ethernet, along with IP traffic. I wonder if the 128K link is a bottleneck.
I also wonder if the load on this router is the same as the load on the IBM router. When the SDLC device was connected to the IBM router was the IBM router also doing DLSW on the Ethernet and was its uplink also 128 K?
I also notice that there are two access lists defined on the router (101 and 1300) which are not assigned to anything in this config. Where did they come from and what are they doing?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.