Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SDM and Config Editor

While enabling the firewall in SDM, it wiped out the cmd "login local" on my "line con 0". I am not able to find a tool in SDM to add the cmd back in except for ConfigEditor, but I do not know the syntax. I just want to be able to merge the new command back into my running config.

1 REPLY
Hall of Fame Super Silver

Re: SDM and Config Editor

Hello Steve,

if you have telnet or ssh access to the box you can use CLI

telnet box-address

use the user/pwd needed

get enable access

router> enable

router# conf t

router(config)# line con 0

router(config-line)# login local

router(config-line)#end

test console access then if everything is fine:

router# write mem

a username/pwd pair must exist to use this.

Hope to help

Giuseppe

101
Views
0
Helpful
1
Replies
CreatePlease login to create content