Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

SDM login

What are the login for SDM? Why does it need 2 level login?

I recently enabled a ssh access to a local machine. Which means there is a nat to forward port 22 to an internal pc and acl enable port 22 for dialer interface.

After that, when I tried to log into sdm, i was asked to provide ssh user/pass. I tried to use the same one, but failed.

But I still can telnet into the router. And there is no nat translation happening when I tried to login through sdm.

Can anybody explain this to me?

Thanks,

1 REPLY
New Member

Re: SDM login

Hi yaya

Try the line below in global config.

"ip http authentication local"

159
Views
5
Helpful
1
Replies
CreatePlease to create content