SDM with https cause a router to crash.

[CSCO11097290]

Dear all.

My router is 2811.

I issue https to connect SDM.

There is no respone on my Internet Explorer.

The console message shows router crash and reboot immediatly after I issue https connection.

If I connect to SDM by using http.

Everything works very fine.

Could someone please tell me the solution to make https works as well as http.

thanks a lot.

PS. My IOS was upgraded to 2811NM with advanced IP service.

[htarra]

There are some other very serious SDM bugs in that version. Your crash tracebacks aren't as important as the fact that the HTTP CP process has overflowed it's stack:

---- Partial decode of process block ----

Pid 3: Process "HTTP CP "

[snip]

---- Current Process Stack (0x2EE0 bytes used, out of 0x2EE0 available)

----

CSCek55001 will crash the router when trying to access the router via SDM (If I remember correctly, this can have the exact same signature as your crash)CSCsg89879 will crash the router when trying to install SDM