There should be a button on the right hand side, the symbol is two arrows pointing down. Click on the button and the firewall section should open. If it is empty then there is no configuration made and you would have to create one. Go to [configure] and select [Interfaces and connections]. Double click on the outside interface. In the window that opens select the tab [Association]. The middle section on the page has [inspect rule], both for inbound and outbound. Normally the firewall is set for outbound so click on the drop down button and select one of the inspection rules.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.