I am using an 871 to connect to an ISP that requires my outside inteface to be in DHCP mode. I give the ISP the MAC address of this interface and my "static" IP is assigned via DHCP based on this MAC. Now I need a second IP and the ISP is asking for a 2nd MAC?! Is it possible to do this? I realize that I could have the ISP route a public block of IPs to my first IP but this setup is in a South American country where that option is not available. Any ideas?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...