Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Selecting a router to terminate a T3 Circuit?

We have a new T3 circuit to terminate.

Will a 2811 router, T3 module included, handle the job? I'd like to save the cost difference of a 3825 router.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Selecting a router to terminate a T3 Circuit?

Roy

It would depend on whether it is a full T3 or partial T3. I believe that a 2811 would not support a full T3. If it were a partial T3 and with not a lot of services configured the 2811 might do, but I believe that it would be marginal.

HTH

Rick

2 REPLIES
Hall of Fame Super Gold

Re: Selecting a router to terminate a T3 Circuit?

Roy

It would depend on whether it is a full T3 or partial T3. I believe that a 2811 would not support a full T3. If it were a partial T3 and with not a lot of services configured the 2811 might do, but I believe that it would be marginal.

HTH

Rick

Hall of Fame Super Gold

Re: Selecting a router to terminate a T3 Circuit?

Roy

I am glad that my response was helpful. Thank you for using the rating system to indicate that your question was resolved (and thanks for the rating). It makes the forum more useful when people can read a question and can know that there was a response which did resolve the question.

The forum is an excellent place to learn about Cisco networking. I encourage you to continue your participation in the forum.

HTH

Rick

123
Views
0
Helpful
2
Replies
CreatePlease to create content