12-04-2008 12:22 PM - edited 03-04-2019 12:36 AM
We have a new T3 circuit to terminate.
Will a 2811 router, T3 module included, handle the job? I'd like to save the cost difference of a 3825 router.
Solved! Go to Solution.
12-04-2008 02:03 PM
Roy
It would depend on whether it is a full T3 or partial T3. I believe that a 2811 would not support a full T3. If it were a partial T3 and with not a lot of services configured the 2811 might do, but I believe that it would be marginal.
HTH
Rick
12-04-2008 02:03 PM
Roy
It would depend on whether it is a full T3 or partial T3. I believe that a 2811 would not support a full T3. If it were a partial T3 and with not a lot of services configured the 2811 might do, but I believe that it would be marginal.
HTH
Rick
12-05-2008 08:47 AM
Roy
I am glad that my response was helpful. Thank you for using the rating system to indicate that your question was resolved (and thanks for the rating). It makes the forum more useful when people can read a question and can know that there was a response which did resolve the question.
The forum is an excellent place to learn about Cisco networking. I encourage you to continue your participation in the forum.
HTH
Rick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide