I have a T1 setup bewteen my two offices with 2661 routers on both sides and WIC 1T1-DSU cards in each. Using these cards can I chanelize the link? I want to create to separate circuits, one with 500kb and the other with 1mb.
AFAIK, this card only supports a single T1 or a fractional T1 - it does not support channelised T1. Therefore, you cannot do what you want with this card. You will need to get a VWIC-1MFT-T1 or a VWIC2-1MFT-T1 card for what you require.
A fractional T1 is a sub-T1 circuit. Usually, cards that only support fractional T1 will only let you configure one such fractional T1 on a port - the card you have is one such card. A channelised T1 card, on the other hand, will let you configure multiple "fractional T1" circuits on the same port. The VWIC will let you do that - on a single physical port.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.