Serial and Ethernet Bridging Using IRB - Transparent Bridging
I have a requirement for one of our services to be offered that Serial and Ethernet Interface should be included under a Single BVI. Essentially this is required to monitor the network as customer does not allow us to touch the CE. In the attached diagram this is facilitated using a 2821 router(iDevice) along with Cisco 3845 and Cisco 1841.I was keen to know whether the concept of IRB would work in case of Serial Interface and it the answer is yes, it would be of great help to have the configuration. If needed i can upload the configuration files.
Re: Serial and Ethernet Bridging Using IRB - Transparent Bridgin
Many thanks. While its defnitely understandable that it enables the bridging between two Ethernet Interfaces, what am keen is to have the serial also included into the same bridging group so that the BVI / Routing Interface does not act as an IP HoP. Please suggest ..
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.