Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Serial cables

I am trying to connect 2500 and 2600 routers back to back. I have WIC-2T and WIC-1T in 2600. IS it possible to connect WIC-2T with CAB-SS-V35FC DCE and CAB-V35MT on 2500 end.

Please guide.

1 REPLY
Bronze

Re: Serial cables

Yes. I have done this very thing. Remember you have to set a "clock rate" on the serial interface on the DCE (2600 WIC-2T) end for the serial protocol to come up.

Also the clock rate must not exceed the maximum speed of either port (if one port is an A/S port, like on a 2522, then maximum is 115200, for example). A 2500 s0 port can do T1/E1 speed.

http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b0858.shtml

198
Views
0
Helpful
1
Replies
CreatePlease to create content