I am having 30 branch locations and each branch location is connected to central location with 2 Mbps leased line. At the Hub location is it possible for me to pur 30 Serial to Ethernet converter and connect the links to a L3 switch? I want to avoid using a higher end router with 30 2 Mbps interfaces.....
Hard to say, maybe you ask the vendor selling you the converters - ask for POC by trying one or two.
There are other options also, which changing the line to MPLS or MetroE (point-to-multipoint). Check the interface needed, compare the one-time and recuring cost with existing one (including the 30 converter).
Hi, a "serial to ethernet converter" is exactly a router, so there is no way you can avoid using one. Check with your SP if they would provide an ethernet interface, that can result more practical for you.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...