Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Serial with VWIC2-2MFT-T1/E1 CARD

Hi ! really appreciate if somebody has this solution/ever encountered this problem:-

Wan conncations point to point

================================

I've one side cisco router with wic 2T serial card the others side is VWIC2-MFT-T1/EI ehich is second gen of e1/t1 card, i understand this card is not supporting (channel-group unframe) so i configured timeslot 1-31 to make full use of 2 mb line, but the line is refuse to up, i swapped with test router (witH wic2t) it's working fine which means the line is ok... any explainnation would be much appreciated...

Thanks

2 REPLIES

Re: Serial with VWIC2-2MFT-T1/E1 CARD

Hi!

For this card: VWIC2-MFT-T1/E1 did you specified to use T1?

Or better can you paste here your configs from both sides?

Thanks!

Cheers,

Calin

New Member

Re: Serial with VWIC2-2MFT-T1/E1 CARD

Hi Calin, I think I solved the problem, it's due to the setting at the NT, this card support structed but the modem at the remote side is setting unstrusted, once change to structed the line up immediately...

Thanks man..

115
Views
0
Helpful
2
Replies
CreatePlease to create content