Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Serial1/0:0 is reset, line protocol is down

Hi, we have an E1 running in our remote european office and noticed the interface was in a reset state. I opened a ticket with the vendor but it ended coming back up on it's own during the call.

Any ideas what the "reset" means? I am learning in CCNA that i thought there is only up, down, up, up or down, down.

Any ideas?

Thanks,

Andrew

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Serial1/0:0 is reset, line protocol is down

When interface is down, router periodically tries to bring it back by resetting hardware. You took the show interface during one one these events.

Hope this helps, please rate post if it does!

1 REPLY
Hall of Fame Super Gold

Re: Serial1/0:0 is reset, line protocol is down

When interface is down, router periodically tries to bring it back by resetting hardware. You took the show interface during one one these events.

Hope this helps, please rate post if it does!

548
Views
3
Helpful
1
Replies
CreatePlease to create content