Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

server teaming on Cisco 3750 Stack

We have 2 Cisco 3750 stacked and we are trying to team 1 HP server on it.

We have observed that since the same MAC is learnt on 2 switch ports, the port is flapping.

What is the way out?

-Sai.

3 REPLIES

Re: server teaming on Cisco 3750 Stack

Set the NICs to failover versus load balance.

Hope that helps

New Member

Re: server teaming on Cisco 3750 Stack

create an etherchannel on the switch, mode on usually works the best. On the server side select switch assisted.

New Member

Re: server teaming on Cisco 3750 Stack

I would set up lacp etherchannel between the HP server and the switch stack in a cross-stack configuration. I know HP servers support 802.3ad lacp because I have many of them running in this fashion. Lacp will control the load-balancing and will only allow 1 mac-address to be used in the nic team.

374
Views
0
Helpful
3
Replies
CreatePlease login to create content