Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

service-module...?

Hi,

A 1700 router, ver 12.3(22) does not accept the following commands under int s0 . Any suggestions would be appreciated to configure the router.

Thanks.

service-module t1 clock source line

service-module t1 data-coding normal

service-module t1 framing esf

service-module t1 linecode b8zs

service-module t1 lbo none

service-module t1 remote-alarm-enable

service-module t1 timeslots 1-24 speed 64

service-module t1 fdl both

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: service-module...?

Said

For some cards those commands are done with service-module commands under the serial interface and for some they are done as commands under the controller. What kind of card is in the router that you are attempting to configure?

HTH

Rick

4 REPLIES
Hall of Fame Super Gold

Re: service-module...?

You might need an IPOS upgrade, which exact hardware do you have, please send "show diag".

Hall of Fame Super Gold

Re: service-module...?

Said

For some cards those commands are done with service-module commands under the serial interface and for some they are done as commands under the controller. What kind of card is in the router that you are attempting to configure?

HTH

Rick

Community Member

Re: service-module...?

Rick,

After posting the question, I realized it could be the WIC card. I am using a serial WIC card on the 1720 series router to test the point-to-point configuration on the router with a 2612 router with serial WIC card. The production router has a RJ45 WIC interface. The commands were accepted by the production router.

Thanks.

Said

Community Member

Re: service-module...?

sh diag

Slot 0:

C1720 1FE Mainboard Port adapter, 2 ports

Port adapter is analyzed

Port adapter insertion time unknown

EEPROM contents at hardware discovery:

Hardware Revision : 6.1

PCB Serial Number : JAD05510M9Z

Part Number : 73-3201-06

Board Revision : A0

Fab Version : 04

Product (FRU) Number : CISCO1720

EEPROM format version 4

EEPROM contents (hex):

0x00: 04 FF 40 00 B2 41 06 01 C1 8B 4A 41 44 30 35 35

0x10: 31 30 4D 39 5A 82 49 0C 81 06 42 41 30 02 04 FF

0x20: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x30: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x40: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

WIC/VIC Slot 0:

--More-- Serial 1T

Hardware revision 1.0 Board revision M0

Serial number 0030806045 Part number 800-01514-01

FRU Part Number WIC-1T=

Test history 0x00 RMA number 00-00-00

Connector type WAN Module

EEPROM format version 1

EEPROM contents (hex):

0x20: 01 02 01 00 01 D6 10 1D 50 05 EA 01 00 00 00 00

0x30: B0 00 00 00 03 11 08 01 FF FF FF FF FF FF FF FF

200
Views
0
Helpful
4
Replies
CreatePlease to create content