Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Set COS for in-band management on ASR901 interface vlan

I am trying to determine how to mark a p-bit of 2 for management traffic leaving an ASR901.  My configuration is in a ring topology, so I have 2 network facing ports and I am using in-band management.  I would like to mark both the management traffic (ssh, snmp, ntp, etc.) as well as MSTP BPDU's. 

It appears that the vlan interface that I am using for in-band management (interface vlan 2) will only accept CPL/control plane service policies and I don't see that there is any option for marking a p-bit in control plane policies.

Can anyone help with this?

bridge-domain 2

interface GigabitEthernet0/7

description "Network link to fes2402 e26"

media-type sfp

no negotiation auto

service-policy input NETWORK-input

service-policy output NETWORK-output

service instance 2 ethernet

  description MANAGEMENT

  encapsulation dot1q 2

  rewrite ingress tag pop 1 symmetric

  bridge-domain 2

interface GigabitEthernet0/6

description "Network link to fes12gcf e1"

load-interval 30

media-type sfp

no negotiation auto

service-policy input NETWORK-input

service-policy output NETWORK-output

service instance 2 ethernet

  description MANAGEMENT

  encapsulation dot1q 2

  rewrite ingress tag pop 1 symmetric

  bridge-domain 2

 

interface Vlan2

description IN-BAND-MANAGEMENT

ip address 10.170.13.153 255.255.255.224

end

  • WAN Routing and Switching
Everyone's tags (5)
252
Views
0
Helpful
0
Replies
This widget could not be displayed.