Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Set dialer in a Cisco 2800 Series

Hello Folks,

we have a problem when i try to set a dialer connection in a Cisco 2800, series.

When i set the type of encapsulation in the interface bri it appears this message:

"Encapsulation not allowed on voice only interface", what does it mean?, i imagine that it's not neccesary to set the type of encapsulation into interface bri , isn't it?. Also, i can't set the dialer pool-member.

thanks in advanced

regards

Alfonso

2 REPLIES
New Member

Re: Set dialer in a Cisco 2800 Series

i forgot, the ios is Version 12.4(13r)T.

thanks

Bronze

Re: Set dialer in a Cisco 2800 Series

Hi there,

You might have put the card into a voice slot. Try moving the WIC to slot 2 as I think slot 0 is only used for voice interface cards. Slots 1 and 3 are HWIC slots, slot 0 is the VWIC slot and slot 2 is the VIC/WIC/VWIC slot.

I hope that works for you!

513
Views
0
Helpful
2
Replies