Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Setting EIGRP Hold Timer Longer Than GRE Recursive Routing Loop Timer

I'm tired of adjacency rediscovery because GRE downs/ups an interface to force EIGRP to discover routes again after EIGRP mistankenly accepts a route to a distance tunnel loopback via the tunnel. I want to increase the EIGRP hold timers to greater than that to stop GRE from forcing my network from converging so many times a day. How long does it take for GRE to shut down/up an interface? I will then increase the hold timer to greater than that interval.

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Setting EIGRP Hold Timer Longer Than GRE Recursive Routing L

Why don't you block tunnel destination whic it is learning from tunnel itself? You can use distribute-list or distance commands to stop learning destination routes in EIGRP.

HTH

Saju

Pls rate helpful posts

2 REPLIES
Silver

Re: Setting EIGRP Hold Timer Longer Than GRE Recursive Routing L

Why don't you block tunnel destination whic it is learning from tunnel itself? You can use distribute-list or distance commands to stop learning destination routes in EIGRP.

HTH

Saju

Pls rate helpful posts

Setting EIGRP Hold Timer Longer Than GRE Recursive Routing Loop

How about just not adding the network to EIGRP command?

So if the remote loopback IP is x.x.x.x and local is y.y.y.y

Why not just configure the local EIGRP without "y.y.y.y"?

455
Views
0
Helpful
2
Replies
CreatePlease to create content