Setting up 1811 for new connection

[wesweekswta]

Hello all

I have 2 networks set up on cable modems with routers and vpns attached. I also have a new fiber connection which I hope to move these networks over to behind a 1811 router. my ISP has given me an IP address for the Wan port and an IP 8-block. I just cant seem to figure out how to pass these IPs on to the routers under the 1811. I have been using the SDM gui interface, not familiar with the cli.

Thanks for your assistance

[aghaznavi]

configure the http server option in your 1811 and access through any one of the workstation through browser and configure the necessary things.