Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Setting up BGP for the first time

Hi all

I am looking to peer with my upstream provider.

I am sure that i am going to have to use BGP.

I have signed up with afrinic to receive IP addresses and become a local LIR.

Here are my questions:

1) I have 2 3620 routers with version 11 IOS on them. Both have 64 Mb of RAM - what will i need to upgrade these to.

2) i am going to be running a Serial (1MB) and 2 wireless Links (54MB) from my upstream provider the 3620 came with 2 ethers - i want to replace one of the slots with a 2FE2W and move everything i have running on 3 routers to these routers on each side. (lets assume that the links all originate from the same upstream ISP for easy of explanation). What amount of ram will i need and will the 3 ether ports be enough should i plan for more ??

3) What IOS release can do cflows and smtp flows ?? i think our 2610 has version 12.3 6a ISP release the 27MB one.

Thanks

Looking forward to your responses - this will help with my planning

Regards

Malcolm

1 REPLY
Silver

Re: Setting up BGP for the first time

The ios version 12.0 and later will support the specifiactions.For further information look at the following URL:

http://cisco.com/en/US/products/hw/modules/ps2797/products_data_sheet09186a008010fba2.html#wp39309

93
Views
0
Helpful
1
Replies
CreatePlease login to create content