Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Setting up Frame Relay

I have a 2811 router that I am trying to run a test on for a project. I have been given a NM-HDV2-2T1/E1. Can I set up frame relay on this and if so how would I do it? Here is a sample of the commands I would like to use...

On physical interface

mtu 4400

no ip address

encapsulation frame-relay IETF

ip route-cache flow

frame-relay lmi-type ansi

On sub-interface...

interface Serial0/0.476 point-to-point

description PPVC SC100

bandwidth 128

ip address 10.98.44.1 255.255.255.0

traffic-shape rate 128000 7936 7936 1000

traffic-shape adaptive 96000

frame-relay class primary

Can this be done using that module??

2 REPLIES
New Member

Re: Setting up Frame Relay

Yeah, I actually meant to put it on this forum but without paying attention I placed it on the LAN forum. Sorry. This post can be deleted as the answers I was looking for are on the other post.

110
Views
0
Helpful
2
Replies