Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Silver

SGBP

Has anyone worked on this protocol? I am having a scenario where i have Channelized E1 links. 5 of them between Rtr1 and Rtr2 and another 5 between Rtr3 and Rtr4. Now I am going to use multigroup configuration to bind these channelized E1 links. But is there a way to bind the Rtr 1 and rtr3 links to gether? Multichassis? i have a powerful routers 7200 series but I was confused going through the document describing SGBP

Rtr1------Rtr2

Rtr3------Rtr4

-Hoogen

3 REPLIES
Hall of Fame Super Silver

Re: SGBP

Hoogen

I have done just a little with multi chassis multilink. Stack Group Bidding Protocol (SGBP) does allow you to group together the links from Rtr1 and Rtr3 (and Rtr2 and Rtr4).

HTH

Rick

Silver

Re: SGBP

Thanks a lot for your reply Rick, any sample configuration that you might suggest for this scenario?

-Hoogen

Bronze

Re: SGBP

Here's a link that can get you pointed in the right direction.

http://www.cisco.com/en/US/tech/tk713/tk507/technologies_tech_note09186a008009408f.shtml#sgbp

Daniel

582
Views
0
Helpful
3
Replies
CreatePlease to create content