Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Sh arp command using Vrf-lite on 3750 ?

We have a vrf-lite routing instance setup on a 3750 network which runs fine. However we can't work out how to do a sh arp table for the vrf. A sh arp in the global routing table works fine.

But the command doesn't seem to exist for the vrf. We are running 12.2(25)SEE3.

Have tried the following

sh arp vrf name but comes back with

#sh arp vrf education ?

% Unrecognized command

Any ideas why this occurs, is it not supported in the IOS version we are running?

Cheers

2 REPLIES
Silver

Re: Sh arp command using Vrf-lite on 3750 ?

Yes, that IOS not supporting that command.

you can see all are available commands in 12.2(25)SEE

Click on S... available show commands are there.

http://www.cisco.com/en/US/docs/switches/lan/catalyst3550/software/release/12.2_25_see/command/reference/ComRef.html#LTR_S

Regards,

Dharmesh Purohit

New Member

Re: Sh arp command using Vrf-lite on 3750 ?

Thanks for that, do you know if the command is supported in later releases?

480
Views
0
Helpful
2
Replies