Sh controller or any other command able to exactly show the line speed
I've one cisco 72xx series with some 8 V35 serial ports. If I run, for example, the command sh controller s1/0 I can exactly get the line speed of the PTT csu/dsu connected to this serial port.
The same command, used on any kind of router different than a cisco 72xx, doesn't let me get the line speed provided by the PTT equipment and sometimes,during troubleshooting, could be useful being able to be sure that local PTT exactly configured the dsu/csu at the speed required,
Do somebody know another kind of command I could use to get this useful information?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.