Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

sh diag gives me WIC/VIC-E1,DUAL= in port one what card is this

Replacing an old router at a remote site - I can log on remote and can see the following card

after a sh diag i can see this in slot 1

WIC/VIC-E1,DUAL=

what Card is this any one know ? -- i think

VWIC2-1MFT-T1/E1 would be the same equivmant in a modern router , can anyone confirm

- regards bob

  • WAN Routing and Switching
3 REPLIES
Hall of Fame Super Gold

sh diag gives me WIC/VIC-E1,DUAL= in port one what card is this

Post the complete output of show version, and show diag.

New Member

sh diag gives me WIC/VIC-E1,DUAL= in port one what card is this

        WIC/VIC Slot 1:

        E1 (2 port) Multi-Flex Trunk WAN daughter card

        Hardware revision 1.0   Board revision D0

        Serial number         Part number    800-04479-03

        FRU Part Number   WIC/VIC-E1,DUAL=

sh diag gives me WIC/VIC-E1,DUAL= in port one what card is this

This part number is generally for the module: VWIC-2MFT-E1=

But I would suggest you to issue the command "show inventory" and see the actual part number, if this command works on your router's platform

468
Views
0
Helpful
3
Replies
This widget could not be displayed.