Shaping doesn't work on a gigE interface..options?
Please see the attachement. I have a 622Mbps circuit that's connected to a gigE interface on my router.
I only want to use 311Mbps out of the entire 622Mbps pipe. When I try to apply the shaping command, it replys that commad is not supported on this interface. What are my other options to restrict that interface and minimize output drops. Any sample configuration would be greatly appreicated.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...