Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Shapping first or CBWFQ ?

For the below conf , what takes place first ?

shapping--->>CBWFQ-->Policing

OR

Policing--->>CBWFQ-->>shapping

interface Serial0/0/0.1 point-to-point

ip address x.x.x.x 255.255.255.252

frame-relay interface-dlci 539<<--FRTS

class COS-OUT-S0/0/0.1

policy-map COS-OUT-S0/0/0.1

class DSCP-OUT-D1

bandwidth remaining percent 60

random-detect dscp-based

service-policy COS-OUT-D1-S0/0/0.1

policy-map COS-OUT-D1-S0/0/0.1

class DSCP-OUT-D1INP

police cir 1232000 bc 154000 be 154000

conform-action transmit

exceed-action set-dscp-transmit 28

2 REPLIES

Re: Shapping first or CBWFQ ?

neither of the two. your config would do cbwfq then police. there's no "shape" keyword command in your policy-map config.

New Member

Re: Shapping first or CBWFQ ?

John

No in fact we do have FRTS on the DLCI , I just did not want to add it so as not make the post too long , I only add "<<--FRTS" to the DLCI

map-class frame-relay COS-OUT-S0/0/0.1

frame-relay cir 1986560

frame-relay bc 40960

frame-relay be 0

frame-relay mincir 1986560

service-policy output COS-OUT-S0/0/0.1

134
Views
0
Helpful
2
Replies
CreatePlease to create content