Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Shared Service Policies

In Cisco devices, when you create a service policy and apply it to more than one interface, does each interface get rate limited individually according to the rate specified in the policy, or is the rate shared between the interfaces such that the sum of traffic across the interfaces cannot exceed the rate specified in the policy?  

Everyone's tags (1)
3 REPLIES
Community Member

This discussion has been

This discussion has been reposted from Top Contributors to the WAN, Routing and Switching community.

Silver

Hi Gabriel,the interfaces

Hi Gabriel,

the interfaces will be rate limited individually to the value specified in the policy-map.

Best Regards,

Jose.

Super Bronze

DisclaimerThe Author of this

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Additionally, if you're using an IOS that support percentages, and use percentages, the percentages will be specific to the interface too.

46
Views
0
Helpful
3
Replies
CreatePlease to create content