Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Sharing Internet Link

Dear All,

We want to share our head office internet link with regional office users.

Existing Setup at head office = Internet Lease Link with bandwidth = 2Mbps over Ethernet interface.

Proposed setup = Additional point to point link between head office and regional office over ethernet.

Requirement = Serve internet to regional office lan users from head office internet pipe using subinterface on the internet router at head office and natting the regional office lan.

Do we need to enable dot1q on the switch where the regional office point to point link will terminate.

Pls suggest.

Regards

5 REPLIES
New Member

Re: Sharing Internet Link

Attached diagram for reference.

Re: Sharing Internet Link

Hi ,

If you have multiple regional offices to be terminated on the switch and going to have a trunk to the router for L3 termination , then dot1q needs to be enabled in your switch and your router sub-interfaces for correspodning vlans

on switch :

switchport trunk encapsulation dot1q

switchport trunk allowed vlan x,y...

on router :

int fa0/0.1 --- 1st regional office

encapsulation dot1q x

ip address

int fa0/0.2 --- 2nd regional office

encapsulation dot1q y

ip address

Hope this helps.

regards

vanesh k

New Member

Re: Sharing Internet Link

What if the switch is not supporting vlan and is unmanaged switch.

Re: Sharing Internet Link

Hi ,

If your switch us a unmanaged one , then you can have one point to point link on the default vlan , no sub-interfaces required and no trunk , need to make sure your Ethernet provider would give a Ethernet link without any Vlan specification.

If you require another point to point link , its not possible.

Hope this helps

regards

vanesh k

Silver

Re: Sharing Internet Link

In addition to Vanesh's post, I assume your PTT support VLAN, so you can enable two VLAN (one for Internet & one for remote office).

Then you have to use the Internet router to carry the routing between VLANs.

At the remote office, it depends on the PTT that it may not require a VLAN supported LAN switch.

You better check w/ local PTT what they can provide and their limitation on the Metro Ethernet service.

Hope this helps.

128
Views
0
Helpful
5
Replies
CreatePlease to create content