Thanks for your reply. Its really helpfull Can you please also help me how to bundle these 4 SDSL lines together. I want to use all of these 4 sdsl lines as one link. how the ISP provides the bonded service.
Since you have only 4 SDSL lines you can buy only 2 WIC's as the mentioned WIC supports 4-Wire mode. And you can arrange with your service provider to provision double speed links over 4-wire. Also it can work as separate 2wire lines over a single WIC
Regarding the bundling of the 4-links I think that you can use a tunnel interface between your router and service provider router but you should 1st check the service provider bundling policy.
If both the 4 links have the same BW then you can load balance over these links using static route also you have to inform your service provider to load balance the return traffic
And you can also create a tunnel interface that runs over the load balanced links, and that will act as a bundle for the 4 links and in case of adding any routes (Dynamic or static) you have to use the tunnel interface and that will handle the load sharing over the 4 links.
But before using the load balancing and bundling you have to enable ip cef and choose load sharing technique (per-packet or per-destination). And that depends on your traffic type.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.