Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SHDSL line aggregation

Hello people,

Thanks to give your insights on below.

I have a client who has 2 point to point links between 2 sites.

The point to point links are of type SHDSL from two different service providers.

A ---------------------  B (ISP 1)

A ---------------------  B (ISP 2)

Is there some load balancing or aggregation that can be done on these 2 links. Client would prefer not using one line only for backup.

Thanks to point me in the right direction.

 

Vijen

 

  • WAN Routing and Switching
1 REPLY

Hello

Hello you dont say what routing you are using dyanmic or static?

However you with static you can basically use two default routes:

ip route 0.0.0.0 0.0.0.0 isp1

ip route 0.0.0.0 0.0.0.0 isp2

 

Dyanmic routing you can also load share but it all depends what routing protocol you are using?

 

res paul

Please don't forget to rate any posts that have been helpful. Thanks.
58
Views
0
Helpful
1
Replies