Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

shdsl

Hi All

I have been trying to make this board work , with the below configuration , but unsuccefully .

HWIC-4SHDSL , G.HS G.SHDSL , DSLSAR , ITU G.991.2 G.994.1

DSLAM Interoperability

Alcatel ASAM 7300 (12-port Conexant-based line card)

ECI HiFocus SAM 480 (16-port Infineon-based line card)

Lucent Stinger FS (48- and 72-port Conexant-based line cards)

!

Alcatel ASAM 7300 , SMLT-A , LDP7AA46.017

ECI HiFocus SAM 480 , STUC-16 , S3_8.10.10

Lucent Stinger FS , STGR-LIM-SL-72 , 9.7.3 (R3.0.2)

Lucent Stinger FS , STGR-LIM-SL-48 , 9.7.3 (R3.0.2)

!

controller SHDSL 0/1/0

termination cpe

dsl-group 0 pairs 0, 1

shdsl annex B

shdsl rate 4096

I found a document that says :

The 2-pair and 4-pair G.SHDSL HWICs supersede the existing G.SHDSL WAN Interface

Card (part number WIC-1SHDSL-V3), which is a WIC-based G.SHDSL solution.

The two new G.SHDSL HWICs provide higher performance and increased reach when

compared to the G.SHDSL WIC.

The working board has the following configuration :

WIC-1SHDSL-V3 , G.SHDSL , MPC ATMSAR, ITU G.991.2

DSLAM Interoperability

Alcatel ASAM 7300 (12- and 24-Port Line Cards)

ECI HiFocus SAM 240 (16-Port Metalink-Based Line Cards)

Lucent Stinger FS (32- and 48-Port Line Cards)

!

controller DSL 0/3/0

mode atm

line-term cpe

line-mode 4-wire standard

dsl-mode shdsl symmetric annex B

ignore-error-duration 30

snr margin current disable

snr margin snext disable

line-rate 4096

Thanks,

Patrizio

206
Views
0
Helpful
0
Replies
CreatePlease to create content